Disaster Cub Scales: Upgrade Your G10 Handle

Quick answer

Upgrading your Disaster Cub to two-tone G10 scales with textured grip is a straightforward bolt-on swap that requires only a T8 Torx driver and about 10 minutes.

Step-by-step scale replacement

1. Remove the old scales: Use a T8 Torx driver to unscrew the Allen bolts on the handle. Keep the bolts in a dish – some are shorter than others. Remove both scales. Common mistake: mixing up bolt lengths. Lay them out in order as you remove them.
2. Install the new G10 scales: Place the new scales onto the handle liners. The textured side should face outward. Align the screw holes with the liner holes and press the scales flush. Check that the scale back is fully seated so the liner sits flat – a gap here will cause wobble.
3. Secure with the included Allen bolts: Insert the bolts from the opposite side and thread them in by hand first. Then tighten with the T8 driver in a star pattern to apply even pressure. Stop turning when you feel resistance – overtightening can strip the liner threads.
4. Test for function and feel: Open and close the blade a few times. Check for scale rubbing. Grip the handle to verify the textured surface feels secure. If the blade drags, loosen the pivot screw slightly and re-tighten the scale bolts.

What you need

• Disaster Cub Scales- Coyote and OD Green G10, Allen Bolts, Textured Grip: Two-tone coyote brown and OD green G10 construction with textured grip. Includes matching Allen bolts. Fits most production Disaster Cub knives from 2020 forward. You get a direct visual upgrade plus measurable traction improvement, and all required hardware is included.